Area of research
Materials Chemistry · Mechanical Engineering
Research interest
Research interests include Materials science, Microstructure, Composite material, Alloy, Ultimate tensile strength, and Spall.
Unusual deformation substructure and strain hardening in an additively manufactured CoCrFeMnNi high entropy alloy under high-velocity impact loading
Longitudinal wave propagation behavior and dimension effect of origami-inspired metamaterials prepared by laser powder bed fusion
Exploring microstructure evolution in CoCrFeNi high-entropy alloy during laser powder bed fusion: A molecular dynamics simulation
H2O2-enhanced electrodeposition repair of cracked concrete in Zn2 + solutions: Mechanisms and performance
Differentiation mechanism of cementitious material permeability and capillary absorption transport path based on 1H NMR
Laser powder bed fusion of Fe60(CoCrNiMn)40 medium-entropy alloy with excellent strength-ductility balance
Laser additive manufacturing of Miura-origami tube inspired quasi-zero stiffness metamaterial with prominent longitudinal wave propagation
Strain rate dependence of mechanical behavior in an AlSi10Mg alloy with different states fabricated by laser powder bed fusion
Spall response and microstructure evolution of additively manufactured AlSi10Mg alloy with different states
Investigation of Compressive Mechanical Properties and Microstructure Evolution of 93W-4.9Ni-2.1Fe Heavy Alloy under a Wide Range of Strain Rates
Flexible guided anti-collision device for bridge pier protection against ship collision: Numerical simulation and ship collision field test
Feedstock preparation, microstructures and mechanical properties for laser-based additive manufacturing of steel matrix composites
Laser additive manufacturing of CoCrNi medium entropy alloy composites reinforced by in-situ nanoprecipitations: Microstructure formation and mechanical properties
Early-Hydration heat and influencing factor analysis of Large-Volume concrete box girder based on equivalent age
Application of ramp-wave loading for spallation tests using a graded generalized impedance flyer
Investigation on the spallation properties and failure mechanism of selective laser melted Ti-6Al-4V alloy with heat treatment under shock load
Orientation-dependent dynamic shearing properties and underlying failure mechanisms of laser powder bed fusion of CoCrFeNi high-entropy alloy
Recent progress on additive manufacturing of multi-material structures with laser powder bed fusion
Hierarchical microstructures and strengthening mechanisms of nano-TiC reinforced CoCrFeMnNi high-entropy alloy composites prepared by laser powder bed fusion
Dynamic compressive properties and underlying failure mechanisms of selective laser melted Ti-6Al-4V alloy under high temperature and strain rate conditions
Influence of asymmetric rolling on the microstructure, texture evolution and mechanical properties of Al–Mg–Si alloy
Enhanced grain refinement and texture weakening in Al–Mg–Si alloy through a novel thermomechanical processing
Mechanism of wear and COF variation of vulcanized rubber under changing loads and sliding velocities: Interpretation at the atomic scale
Temperature-dependent dynamic compressive properties and failure mechanisms of the additively manufactured CoCrFeMnNi high entropy alloy
Corrosion Experimental Research on Local Damage of Epoxy-Coated Steel Bars in Concrete Under Marine Environment
The study of wear particle emissions of soft rubber on rolling contact under braking conditions
Laser additive manufacturing of nano-TiC particles reinforced CoCrFeMnNi high-entropy alloy matrix composites with high strength and ductility
Effect of heating treatment on the microstructural evolution and dynamic tensile properties of Ti-6Al-4V alloy produced by selective laser melting
Relationship among solution heating rate, mechanical properties, microstructure and texture of Al−Mg−Si−Cu alloy
Tensile Mechanical Behavior and Spall Response of a Selective Laser Melted 17-4 PH Stainless Steel