Area of research
Mechanical Engineering · Mechanics of Materials
Research interest
Research focused on Microstructure and Composite material, with related work in Selective laser melting, Acicular, Alloy. Notable publications include 'Mechanisms and characteristics of spatter generation in SLM processing and its effect on the properties', 'Numerical and experimental investigation into the subsequent thermal cycling during selective laser melting of multi-layer 316L stainless steel', and 'Laser additive manufacturing of nano-TiC particles reinforced CoCrFeMnNi high-entropy alloy matrix composites with high strength and ductility'.
Tribological behaviour of laser cladding CoCrFeNiMo0.5Ti -hBN high-entropy alloy composite coatings under dry and tribocorrosion conditions
Longitudinal wave propagation behavior and dimension effect of origami-inspired metamaterials prepared by laser powder bed fusion
Impact behaviors of additively manufactured metals and structures: A review
Deformation-mediated cyclic evolution of precipitates in Al-Mg-Si-Cu alloy by multi-pass ECAP and thermal treatments
Laser additive manufacturing of Miura-origami tube inspired quasi-zero stiffness metamaterial with prominent longitudinal wave propagation
Investigation on the spallation properties and failure mechanism of selective laser melted Ti-6Al-4V alloy with heat treatment under shock load
Dynamic compressive properties and underlying failure mechanisms of selective laser melted Ti-6Al-4V alloy under high temperature and strain rate conditions
Densification, Tailored Microstructure, and Mechanical Properties of Selective Laser Melted Ti–6Al–4V Alloy via Annealing Heat Treatment
Effects of laser energy density on carbide dissolution, element distribution and microstructure evolution of AISI P20 steel after laser surface quenching
Laser additive manufacturing of nano-TiC particles reinforced CoCrFeMnNi high-entropy alloy matrix composites with high strength and ductility
Effect of Heat Treatment on the Wear Properties of Selective Laser Melted Ti–6Al–4V Alloy Under Different Loads
A Melt Pool Temperature Model in Laser Powder Bed Fabricated CM247LC Ni Superalloy to Rationalize Crack Formation and Microstructural Inhomogeneities
Investigation into the microstructure and dynamic compressive properties of selective laser melted Ti–6Al–4V alloy with different heating treatments
The effect of laser energy density on the microstructure, residual stress and phase composition of H13 steel treated by laser surface melting
Strain rate dependence of mechanical property in a selective laser melted 17–4 PH stainless steel with different states
Influence of spatter particles contamination on densification behavior and tensile properties of CoCrW manufactured by selective laser melting
Investigation into the dynamic mechanical properties of selective laser melted Ti-6Al-4V alloy at high strain rate tensile loading
Numerical and experimental investigation into the subsequent thermal cycling during selective laser melting of multi-layer 316L stainless steel
Investigation into the influence of laser energy input on selective laser melted thin-walled parts by response surface method
Comparative study on the influence of subsequent thermal cycling on microstructure and mechanical properties of selective laser melted 316L stainless steel
Mechanisms and characteristics of spatter generation in SLM processing and its effect on the properties